[Bioperl-l] Installation problems: "unable to remap"
Paul G Cantalupo
lupey+ at pitt.edu
Fri Nov 18 09:05:32 EST 2005
Jonathan,
The problem is cygwin Perl. See the following:
1) http://sources.redhat.com/ml/cygwin-announce/2005-07/msg00031.html
2) The 'rebase' README file in /usr/share/doc/Cygwin/
Paul
Paul Cantalupo
Research Specialist/Systems Programmer
559 Crawford Hall
Department of Biological Sciences
University of Pittsburgh
Pittsburgh, PA 15260
Work: 412-624-4687
Fax: 412-624-4759
Ask me about Toastmasters: www.toastmasters.org
Midday Club Treasurer
On Fri, 18 Nov 2005, Jonathan Arthur wrote:
> Hello all,
>
> I am having difficulty installing BioPerl. I am running Windows XP
> Professional with cygwin. I am using the CPAN installer to attempt to install
> the Bundle::BioPerl modules.
>
> The installation appears to go relatively smoothly and end normally. It does
> note at the end that there were installation problems with File::Spec,
> GD::SVG, and Data::Stag. Nonetheless, when I try to "use Bio::Perl" Perl
> cannot find the module and exploring /usr/lib confirms the modules are not
> present.
>
> I then tried installing the problem modules above on the assumption that the
> final installation of Bio::Perl was dependent on these modules being
> successfully installed. The creation of the makefile for GD::SVG dies with:
>
> C:\cygwin\bin\perl.exe (800): *** unable to remap
> c:\cygwin\bin\cygfreetype-6.dll to same address as parent(0xE100000) !=
> 0xEA0000
>
> Data::Stag installation experiences a similar error (with different .dll)
> when trying to install the Tk dependency.
>
> File::Spec installation appears to install fine (bar some failed tests
> because it can't load File::Spec::VMS) and it is present in /usr/lib/perl5 so
> it is not clear what the cpan installation is complaining about in regard to
> this module.
>
> Could anyone assist with these installation problems?
>
> Regards,
>
> Jonathan
>
> --
> Dr Jonathan Arthur
> Sesqui Lecturer in Bioinformatics
> Central Clinical School, Faculty of Medicine and SUBIT
> Medical Foundation Building, K25
> University of Sydney
> Ph: +61 2 9036 3132
> Email: jarthur at med.usyd.edu.au
>
>
> _______________________________________________
> Bioperl-l mailing list
> Bioperl-l at portal.open-bio.org
> http://portal.open-bio.org/mailman/listinfo/bioperl-l
>
More information about the Bioperl-l
mailing list